Before buying, please measure the size of your car emblem!
1.Fit for:Toyota(Corolla Camry Prius Rav4 Yaris Chr Supra Wish Auris Highlander)
2. Wiring length: 0.6 M
3. Package include:1 piece Toyota 5D car light
4.Note:If you have any questions,please contact us,and we will reply your message with 24 hours.
Tools prepared before installation:
Please prepare the following tools: 1. Flat screwdriver 2. Cross screwdriver 3. Insulating tape 4. Towel 5. Pliers
1. First, lay a towel next to the trunk logo (to prevent scratching the body), and use a flat screwdriver to pry the logo
2. Peel off the double-sided adhesive tape of the old logo from the car body, gently pry off the logo, and clean up the residual double-sided adhesive tape.
3. Use a cross screwdriver to remove the partition board inside the boot, pay attention to the buckle, and carefully remove the sound insulation board.
4. Install the logo light. The power line of the logo light passes through one of the logo positioning holes and goes into the trunk. Tear off the single-sided adhesive on the back of the car sign lamp, stick the car sign lamp to the body while pulling the cable, and press it tightly.
5. Turn on the power supply after the installation of the logo lamp. Connect the power supply of the rear license lamp to the vehicle logo lamp, so that when the small night lamp is turned on, the vehicle logo lamp will also be turned on at the same time, and find the power connector of the rear license lamp.
6. Unplug the plug, peel a hole at the positive and negative poles, expose the wire core, connect the wire according to red to red and black to black, and don't forget to wrap it with insulating tape, and finally plug the plug back! Replace the boot lid insulator.